Read the full article on the IEEE-SA website. The full article has been removed from the IEEE website. It is posted here in its entirety.
Standard for calibration and use of RF test gear to be revised
Contact:
Shuang Yu, IEEE-SA Marketing Manager
+1 732-981-3424, shuang.yu@ieee.org
Piscataway, N.J., USA, 25 April 2011 – IEEE, the world’s largest professional association advancing technology for humanity, today announced that the IEEE Standards Association (IEEE-SA) Standards Board approved two new projects to develop standards that will limit the injection of harmonic frequencies into the public electric transmission system.
Harmonic pollution is a growing problem caused by the widespread use of power supplies and other non-linear loads. It can result in power loss and equipment damage and it may also be related to environmental safety issues.
Both standards will address harmonic injection in 60Hz and 120V/240V systems such as those in use in the United States, Canada and other regions of the world. Both standards will also use the IEC SC77A and IEC 61000-3-12 standards as seed documents.
Proposed standard IEEE P1836 – Standard for Electromagnetic Compatibility (EMC) – Limits for Harmonic Current Emissions Produced by Equipment Connected to Public Low-Voltage Systems with Input Current <= 16 A Per Phase – will establish limits for equipment and create methodologies for testing and simulation.
Proposed standard IEEE P1837 – Standard for Electromagnetic Compatibility (EMC) – Limits for Harmonic Current Emissions Produced by Equipment Connected to Public Low-Voltage Systems with Input Current >16 and <= 75 A Per Phase – has the same general thrust. Both standards will take the cost of corrective action into consideration and apply the principals of lowest cost solutions.
In addition, the IEEE has initiated a project to revise the standard covering procedures and equipment used to measure electromagnetic emissions. The present standard, IEEE P1309 – Standard for Calibration of Electromagnetic Field Sensors and Probes, Excluding Antennas, from 9 kHz to 40 GHz – will be revised because it has been learned that in some situations RF probes may return values that are significantly different from the calibrated response. This project will provide instructions on probe use, characteristics and related measurement uncertainties. Use factors that may affect the accuracy of the reading will also be reviewed.
Source: IEEE